[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Selectable chips & boost programming
At 11:06 AM 2/28/2000, you wrote:
>David,
>
>Which address lines do you add--A17-A19 ??
>Do you then switch those via the ground pin 16--or are you
>switching through outputs O0-O7 ? If I ask a stupid question,
>please don't respond in kind <g>. Which of the A0-A16's did you apply to the
>socket...I don't have one of these handy, so I've got a lot of questions...
I ran the identically labeled lines for a 27C128 to the ECM. IE: A0-A16,
O0-O7, power, ground, OE, etc. the lines that were additional on the
27C010 should only be A17 thru A19, and those were switched to ground thru
the thumbwheel switch. I can draw up a diagram tonight and send it to you
(and the list for that matter, as much interest as there is!)
===========================================================
David Cooley N5XMT Internet: N5XMT@bellsouth.net
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================