Re: Whatsa 2732DC?

[thergen@svn.net]

Bruce,

I don't know the direct answer to your question.  In the past when I've
had a similiar problem, I started with lowest programming voltage and
worked my way up until I got reliable results.  I think the 2732 series
used 12.5v, 21v, and 25v.  For reading, I would just use the lowest
voltage available (the low budget programmers I've used only supply 5v to
the eprom during reading).  If I was designing some mission critical life
support equipment, I'd take the time to find the exact answer, but the
approach mentioned has worked well for me.

HTH,
Tom

On Sun, 14 May 2000, nacelp wrote:

> Is a 2732DC the "same" as a 2732A as far as programming voltage / reading?.
> TIA
> Grumpy
> 

>