Re: GM Powertrain

[ron harris <harris1@execpc.com>]

Hi Ron Harris here i am also new to the list and looking for MEFI3 programing
options. I  am working on supercharger kits for mercury 502 engines. Any info on
reading ,copying, programing would be appreciated. Thanks

Shannen Durphey wrote:

> MEFI3 system is sold with the Ram-jet engine pictured on the front of
> the 2K GM Perf. Parts book.  Small problem, the engine and all it's
> parts are not yet available.  And I haven't been able to find out when
> it will be.  The makers of Diacom, Rhinda (sp?), have worked with MEFI
> and offer some calibrations software for it.  I'd be interested in
> anything that you might find out about the system.
> Shannen
>
> nacelp wrote:
> >
> > Except for some marine manufacturers, and a limited number of folks involved
> > with oem calibrations, I don't know of anyone who has actually even seen one
> > yet.  I think the gm advertising group got way ahead of the production
> > folks.  Also, I've just seen it mentioned with the Retrofit system, might
> > not even be available seperately, or for a while.
> > Grumpy
> >
> > > I'm new to the list and looked through the archives and did not find
> > > much information in regards to the MEFI3.
> > > I'm looking to see what can be done in regards to configuring the unit
> > > for use on a cylinder.
> > > I see that they offer a setup for use with a distributor.
> > > Does anyone know if it can be done DIS with wastefire? or DIS with coil
> > > per cylinder?
> > > Is there a site that I can get good information about the setup? Or does
> > > anyone on the list have information that they can send me?
> > > Thank you
> > > Ken Bauman
> >