[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: B/L INT Numbers
On Fri, 14 Apr 2000, Marteney, Steven J. wrote:
> Ignore this post if I'm wrong, but...
> If you are looking at block learn's with a scanner, doesn't it ONLY display
> the current block learn mult or int? But, block learn's are tabular in
> nature and the table is indexed by TPS and something else. So, naturally,
> if TPS changes you'll see the BLM,BLI change because it jumped to a
> different spot in the table. With constant TPS, the same table spot is used
> and will only change if ECM deems it necessary. Am I all wet? (or green?)
>
> Steve
The table indexing is pretty crude, the table is 4x4 so you can have
quite a wide range of conditions in a single table entry.
And within a single table entry it may need to adjust quite a bit.
Roger