[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Low Impedance Injector driver info
I modify factory ECMs using P&H drivers to run the low impedance injectors.
I use the Cherry Semiconductor P&H drivers to do so. So far, I've only done
GN ECMs (148s), but could easily do a batch fire ECM like the Syclone ones.
Contact me direct if you need more info.
Kendall Frederick
> -----Original Message-----
> From: owner-gmecm@diy-efi.org [mailto:owner-gmecm@diy-efi.org]On Behalf
> Of nacelp
> Sent: Friday, April 14, 2000 11:36 AM
> To: gmecm@diy-efi.org
> Subject: Re: Low Impedance Injector driver info
>
>
> There have been several smoke episodes (doing driver testing), and still
> gathering notes. The first was with 16 saturated (730), then 8 saturated
> injectors, in P+H mode (749). I have run 6 P+Hs with some success, but
> things get real warm, hence looking for a better answer, **I
> THINK** there
> is a temp. where things get erratic before the smoke is let out.
> The 6 P+Hs
> run fine at idle/cruise, but at the faster speeds, things get out of hand
> (erratic), also at times, the injectors sound different, like
> they are going
> to a new firing strategy, but at only higher temps.. If here's
> running that
> way, I hope he's carring a spare ecm or 2..
> Grumpy