[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: FAQ ideas
I'll confirm this, since I just got done mounting a pump from a 351W '89
E350 van under my '71 Cutlass. The outlet is threaded, I tapped it to
1/8" NPT since the existing threads were already crossthreaded. Used 1/8"
to 3/8" inverted flare adapter right to the steel line. Even has a nice
foam sleeve to isolate it from the mounting bracket.
Inlet side is designed for one of those Ford clip-lock (duck-bill? NOT
spring-lock) fittings, 3/8" fuel line will fit over it just fine.
Bosch pump from '75-'80 Caddy Seville or Eldo with the 350 FI motor is also
nice, pump and filter already mounted to a bracket, but plumbing is a bit
more difficult (wierd inlet/outlet fittings).
-> Bob Valentine
-> bob@tecmark.com
At 09:16 PM 6/20/2000 -0500, you wrote:
>
>-> You can also use a pump off of most any FI Ford (choosing the correct
>-> pressure of course). Ford likes to mount the "real" pump on the
>-> frame
>
> EFI Ford trucks are supposed to have a really nice setup, but every one
>I've found in the local yards has already been relieved of the pump!
>
>
>