RE: 2.8v6 tpi and a 730

[David Cooley <n5xmt@triad.rr.com>]

At 03:47 PM 7/18/2000, you wrote:
>Yep...every thing looks fine on diacom......cross counts could be higher..
>Even changed ecm, new o2 sensor, whent heated, ran new harness ground and o2
>wires....
>
>Hard to tell as it only happens when wot???or high speed..


If you're still getting a code 13 but only at WOT, I'd check the TPS...  If 
it's not going over the WOT set point (85% or whatever is in the chip) it 
still thinks it's in part throttle mode, and the steady voltage with no 
cross counts you see at WOT is causing the code 13.


===========================================================
David Cooley N5XMT Internet: N5XMT@triad.rr.com
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
I am Pentium of Borg... Division is Futile!
===========================================================