[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Timing Jump on 165/TPI System

To: gmecm@efi332.eng.ohio-state.edu
Subject: Re: Timing Jump on 165/TPI System
From: Shannen Durphey <shannen@grolen.com>
Date: Sun, 09 Jan 2000 20:29:50 -0500
References: <005e01bf5b06$750bc420$4f5a4dd1@computer>
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu

Mark Romans wrote:
> 
> Hey Bruce: If I disconnect my est connector, should I see the advance at
> 2500 rpm?
Not trying to interrupt, but yes around 2500 it usually jumps 15
degrees or more.

> I am wondering if this is why I have the idle problem.  Remember how the
> signal goes to zero advance?
> Mark
Tell me more.  0 advance all the time?  Is this the same problem you
were battling a year ago?
Shannen

References:
- Re: Timing Jump on 165/TPI System
  - From: Mark Romans <romans@pacbell.net>

Prev by Date: Re: DIS Tach signal
Next by Date: Re: Timing Jump on 165/TPI System
Previous by thread: Re: Timing Jump on 165/TPI System
Next by thread: Re: Timing Jump on 165/TPI System
Index(es):
- Date
- Thread