The Buick is a MAF system using a crank (3
slot) and cam shaft posistion sensor.
The syclone is a MAP system using a
distributor.
Which most closely matches what you have?
You need to run a 2 bar MAP sensor.
Is you 16183082 similiar to any USA ecm?.
Can you use a 808, is your 082 a 128K prom?.
Grumpy
You see, I am wanting to convert my Nissan
system over to delco,ecm sensors,etc from a VR V6 ,16183082 ,
I have a 3 liter turbo engine , (was thinking
that if I could get maps,program out of a V6 turbo buick gn it would be a
better starting point than nothing) ,Will this work???? or am I going to have
to modify the program from the N/A V6 ????
My turbo boost is 15psi, so I know a modified MAP sensor is
on the list,
I am only a beginner ,(although I am a mechanic,tinker
with electronics,basic asm programming the 6502/z80)
my main interest in the delco ecm is in real-time
programming, (Its a must!)
bye for now
Paul