[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Spark Reference Angle for 8 pin HEI module

To: gmecm@efi332.eng.ohio-state.edu
Subject: Spark Reference Angle for 8 pin HEI module
From: Stuart Bunning <stuart@kenelec.com.au>
Date: Tue, 18 Jan 2000 00:21:20 +1100
In-reply-to: <3874E632.C828C6FF@truswood.com>
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu

Hello

I am using a 808 ECM  and a 8 pin HEI module on a straight 6 chrysler
motor. (custom EFI setup)
I have attached a gif of the hei module i'm using.. It's found on a 4
cylinder GM car a camira in australia.
I beleive it's the same module on some chev v8's in USA..


I was wondering what Spark Reference angle I should use in my Binary.
as I have no reference because this motor has never been produced with EFI
on it before and this module has not been used 
on that motor before..

Stuart Bunning

Attachment: hei8pin.gif
Description: GIF image

Follow-Ups:
- Re: Spark Reference Angle for 8 pin HEI module
  - From: "Bruce Plecan" <nacelp@bright.net>

References:
- sitepage(previously 89 MAF Volt...)
  - From: mswayze@truswood.com (Mike Swayze)

Prev by Date: RE: starting point L-plates
Next by Date: Re: Spark Reference Angle for 8 pin HEI module
Previous by thread: sitepage(previously 89 MAF Volt...)
Next by thread: Re: Spark Reference Angle for 8 pin HEI module
Index(es):
- Date
- Thread