Re: Syncing crossfire injection

["Dave Zug" <dzug@delanet.com>]

large face (5")  0 - 10" wc guages are in mech rooms everywhere that I retrofit systems. not very large graduations (60 degree sweep too) but if this will do some good for someone I'll start collecting them... let me know. 

----- Original Message -----

From: Ken Kelly

To: gmecm@efi332.eng.ohio-state.edu

Sent: Monday, January 17, 2000 5:42 PM

Subject: RE: Syncing crossfire injection

Nope, you'll need a gauge that measures in inches of water. Both TBI's need to be sync'ed at 6" of water. 1 inch of mercury is equal to about 40" of water. If you need a gauge, let me know, I have a few extras I'm willing to sell.

 

Ken

-----Original Message-----
From: owner-gmecm@esl.eng.ohio-state.edu [mailto:owner-gmecm@esl.eng.ohio-state.edu]On Behalf Of Kevin Reynolds
Sent: Monday, January 17, 2000 1:51 PM
To: gmecm@efi332.eng.ohio-state.edu
Subject: Syncing crossfire injection

I want to check the synchronization of my crossfire injection, but don't have a manometer.

Is a map sensor connected to a DVM sensitive enough to use for this?

Any other ideas?

Kevin R