Re: Too hot 7805

["Bruce Plecan" <nacelp@bright.net>]

Friend was over with a DVM, measured the draw, was like a 150 ma..  BUT the
working voltage was 13.3...  So put a 25 ohm resistor in series with  the
"In" voltage, dropped to 9 something, and 7805 now comfortable to hold.
Thanks for all the help, now back to getting the signal right........
Grumpy
    Was bad enough when the last incident involved water ski's, now the're
talking snow ski's.  I just betcha we wind up in courst again........

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org