[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
'727 connectors prev:Re: How to identify eprom
so which pin locations are molded over? dis/dissy, egr,..?
byE
Mike
Swayze
mswayze@truswood.com
kswayze@bellsouth.net
----- Original Message -----
From: <Chipsbyal@aol.com>
To: <gmecm@diy-efi.org>
Sent: Sunday, February 06, 2000 11:32 PM
Subject: Re: How to identify eprom
> Dan, one thing to take notice of when getting a 1227727 out of a 3.1 or 2.8
> front wheel drive vehicle is the connectors. Some of these don't allow the
> correct pin locations for the Vette pinout. Some of the terminal locations
> are "Molded over." The V-8 cars have different pinouts than the V-6's. The
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org