Re: DP Ram Emulator...

[Ludis Langens <ludis@cruzers.com>]

Eric Aos wrote:
> 
> > reduced power consumption of standby mode
> 
> Just dropping the CE won't do it then? Will the ECM be ok with pulldown's on
> it's lines?

All the inputs (including bidirectional pins) must be at essentially the
power supply rails.  Otherwise, a CMOS chip will have increased power consumption.

Try pulldowns in the 100K range.  The ECM shouldn't be bothered by such
a high resistance.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org