Re: Conversion table

["Walter Sherwin" <wsherwin@idirect.com>]

Try this............

MAP1volts out = Vref(.01059*[Kpa] - .10941)

Walt.





>Hi,
>
>I'm new to the list so please forgive if I'm covering old ground.  I have
>searched the archives for this info, but unsuccessfully.
>
>I am looking for a conversion table or factor to change voltage output from
>a GM TBI MAP to kPa.  The scantool I have only outputs the sensor data in
>voltage, but my programmer is having difficulty referencing this data to
the
>tables we need to change as they are based on kPa readings.
>
>TIA,
>Ramsey


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org