RE: Debugger board for P4 ECMs

["Bartz, Jamison" <Jamison.Bartz@COMPAQ.com>]

I'm also interested along with Steve...  Please include me in any
correspondence.

Jamie

-----Original Message-----
From: steve ravet [mailto:sravet@arm.com]
Sent: Thursday, February 17, 2000 9:47 AM
To: gmecm@diy-efi.org
Subject: Re: Debugger board for P4 ECMs


I'm interested.  You're saying you can single step, dump mem, etc. from
a PC/MAC?  What software are you using?

--steve

Ludis Langens wrote:
> 
> I've added a simple schematic to my web pages.  It is at:
>   http://www.cruzers.com/~ludis/p4test.gif
> 
> The schematic is of a little peripheral board for P4 ECMs.  It plugs
> onto the edge card test connector of a P4 ECM.  Everything fits on a
> circuit board small enough to fit inside the case of a 1227165.
> 
> The added peripherals let me run a debugger in a P4 ECM.  This is very
> useful for figuring out how the hardware works.  The schematic shows a
> Mac style RS422 serial port.  This could be changed to RS232 with a DB9
> connector for use with PCs.  Is anyone interested in building a copy?
> 
> --
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
> 
>
----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

-- 
Steve Ravet
steve.ravet@arm.com
Advanced Risc Machines, Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org