Re: 1227748 schematic updated

[JTesta1966@aol.com]

In a message dated 2/21/00 12:26:04 PM Eastern Standard Time, sravet@arm.com 
writes:

<< That's just in time.  I'm just starting to look at this ECM for my
 boat.  The archives claim it has a bare EPROM socket, but when I test
 fit an EPROM in there it was very loose, in fact it would fall out if I
 turned it over.  Is there some sort of holder between what's soldered to
 the board and the chip itself?  A plastic thing for the chip itself?  IF
 so does anyone have one they'd part with? >>

Sounds like you need a carrier. I have a spare or 2. As long as its a 2732 
prom. Email me private with mailing info

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jim Testa                                         TType86 on #BuickGN
jtesta1966@aol.com                               buick.fiendish.net:6667
ASE Master Technician            NJ Lic. Motor Vehicle Inspector
L1 Adv Eng Perf Certified     NJ Licensed Emissions repair Tech
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org