Re: V6 ALDL Communications

["Jeremy Gonyou" <jgonyou@hotmail.com>]

> Did you set mode to normal before linking?.
> Grumpy

I.e, no resistors?  Yes.  After the cable comes is out, the car tries to 
resume normal life, but cannot.  I cycled power to the ECM to get it 
drivable again.  Ludis wrote saying that the 3.9 k resistor is to test limp 
home mode.  Guess the netres aren't right on.  However, prime concern:  
still no data.


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org