Re: manifold machining

["nacelp" <nacelp@bright.net>]

I had to read your post 2x to get it,,,  hahahaha
Grumpy
       (once a month we draw straws here to see, who gets to be called
Beavis, and Butthead for a day)

> >How about buying a cheap drill press, and jig the manifold up yourself.
> >Then JB Weld them in.  Set the bung hole depth so they bottom out, and
can't
> >get pushed into the runner.  The drill bit specs have been covered before
> >(for the injector hole).  Take the spec to a machine shop and have them
cut
> >for you.  Lots of times you can get stuff done cheap when they don't know
> >it's a race car part.
>
>
> He said BungHole... Cool!
>
>
>
> ===========================================================
> David Cooley N5XMT Internet: N5XMT@bellsouth.net
> Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
> We are Borg... Prepare to be assimilated!
> ===========================================================
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org