Re: one step back = one step up...

[Shannen Durphey <shannen@grolen.com>]

Running on the bench, for now. ; )
2.2 4cyl later.

Shannen

the Fredericks wrote:
> 
> Shannen,
> What are you running this on?  Lemme know when it works, I want a cheap MAP
> system for my GN...
> 
> Good luck!
> Kendall Frederick
> 
> > -----Original Message-----
> > From: owner-gmecm@diy-efi.org [mailto:owner-gmecm@diy-efi.org]On Behalf
> > Of Shannen Durphey
> > Sent: Monday, April 17, 2000 11:34 PM
> > To: gmecm@diy-efi.org
> > Subject: one step back = one step up...
> >
> >
> > Well, first test of DIS plus 749 Syty code w/ timing light connected
> > looked promising, but was unsuccesful.  Scantool was displaying
> > decreasing advance, as the timing light was showing an increase.
> > Positive side is that the 60 degree ref angle was no problem, with
> > actual advance being measured from 0 to 60 degrees BTDC.
> >
> > Shannen
> > ------------------------------------------------------------------
> > ----------
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> >
> >
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org