Re: GM ECM to run a rotary engine

[David Cooley <n5xmt@bellsouth.net>]

At 05:37 PM 4/28/00, Jason R. Haines wrote:
> Ok, odd question for everyone to think about over the weekend. Could a GM
> ECM (4, 6 or 8 cylinder) be made to run a rotary engine (2 rotor)? I have a
> 13B rotary engine in a 1971 Datsun 510 that I would like to change over to
> EFI one day.


Should be able to... being 2 rotor you'd need a 6 cyl ECM.


===========================================================
David Cooley N5XMT Internet: N5XMT@bellsouth.net
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org