Re: IAT / MATs

["nacelp" <nacelp@bright.net>]

One of the prom editors I have.
Grumpy


> > Anyone have a lead on a 3/8" pipr to 1/4" pipe thread reducer that is
non
> > metallic?.
> > I want to isolate the sensor as much as possible from the heat soaking
of
> > the engine.
> >
> > BTW, the high end of the syty timing mat correction is 130.  So guess
> what?.
> > again ya run outta correction.
> > Brumpy

> Bruce ,
> Where are you getting the 130 figure from?
> Jim Sloan
> leroy@sunflower.com


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org