Re: Gal/Hr and Grm/Sec Info

[Ludis Langens <ludis@cruzers.com>]

JTesta1966@aol.com wrote:
> 
> I saw Ludis' post on this and want to make sure I understood it correctly.
> Did you/are you saying the gal/hr parameter is merely for a trip computer?

It appears that way in the 1227170.

> Like in a car that uses this ECm and is equipped with one, say an Electra or
> something?

The '7170 was used only in the V6 Fiero.

> So I can assume since this GN has no trip/mileage computer it
> doesnt use this (although it DOES have a dig dash), and that parameter will
> have no effect on anything?

A trip computer was never offered in the Fiero - hence the '7170 data
was never used.  I recall seeing ALDL data definitions for other ECMs
that also have this trip computer data.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org