[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Convert 6 cyl tacho for use with 4 cyl
Two questions:
1. What's the cheapest way to convert an analogue electronic tacho,
set up for a 6 cylinder, so it reads correctly for a 4 cylinder.
Assuming there is no access to the internal electronics, just the
external signal from the coil. (logically, the tacho requires 3
pulses for every two pulses the coil generates).
2. What's the easiest way?
Thanks in advance, Peter
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org