Since that ecm does not have cruise control intergrated into it you will have to use the other external modual that came with the diaphram ect. You will need to run a vss wire to the module.. I believe the older modules up to 90 when tpi whet to the 730 and use the same signal as the 165 did for vss. Check out my project at http://www3.sympatico.ca/hawthorn.brae/mikes.htm <http://www3.sympatico.ca/hawthorn.brae/mikes.htm> Mike Rolica Plant A, Magnesium Products Division Strathroy (519)-245-4040 Ext. 265 -----Original Message----- From: Vinnie Moscaritolo [SMTP:vinnie@vmeng.com] Sent: Wednesday, June 07, 2000 12:23 PM To: gmecm@diy-efi.org Subject: Cruise control and 92EFI hey all; I a have a chevy ZZ4 that I am transplanting into a Scout II (really! see http://www.vmeng.com/vinnie/scout/tpi.html ) I would like to add a cruise control unit to this project, before I get to far into it. I am using a 1227730 ECM, and was wondering what best ay to implement cruise control is. I have some GM hardware, (looks like a diaphragm with a throttle cable, and some electronics that came with it ) but I am not married to it. Can anyone point me to some info, maybe a diagram, that describes how this stuff should be hooked up, better yet, is there an alternative box that I could use that doesn't require the vaccum system.. any ideas? Vinnie Moscaritolo KF6WPJ ITCB-IMSH-SKG http://www.vmeng.com/vinnie/ PGP: 3F903472C3AF622D5D918D9BD8B100090B3EF042 ------------------------------------------------------- "There are more things on this planet with fangs, claws, poisons and scales than there are things that are warm fuzzy and full of love. - It's a simple fact" - James A Keating ---------------------------------------------------------------------------- To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes) in the body of a message (not the subject) to majordomo@lists.diy-efi.org
<<application/ms-tnef>>