Re: 727 ECU limits

[dave.williams@chaos.lrk.ar.us (Dave Williams)]

-> The ECM hardware should handle the 12K just fine.  Software will be
-> the problem.  It often has a limit of 6375 rpm.  A few versions
-> support something a bit higher, like 7150 rpm.

 Is this a variable that can be altered, or is the code just not fast
enough to handle 12K?

 I was assuming, since the 727 is batch fire, that there was no
synchronization between the injector pulses and the RPM input.  But...
ah, forgot about the spark signal.  Hmm...
 
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org