Re: Lambda sensors - Where, Why and how Much ?

["Bruce Plecan" <nacelp@bright.net>]

Is this a fact that you know of, or just guessing at?.
If it's cable and connectors that are the only difference why are so many GM
trucks having the rear sensors die in CA?
Grumpy



> You can use any four wire 1V Lambda sensor.The differences  are only in
the
> type of the connector and length of the cable.If your old sensor has AMP
> superseal (four male pins in line) connector you can use Bosch or NTK
> sensors from Fiat/Lancia/Alfa Romeo .Bosch and NTK make many numbers of
the
> sensors with variable length of cable.Typical colors of the wires :
> 1) black-signal out
> 2) gray - signal ground
> 3)2*white- heater
> Marek
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org