Re: BPW and Cylinder Vol.?

[romans@starstream.net (Romans, Mark)]

No I am running an 89 Calibration,  APYP so it starts at


C5B4

Mark

----- Original Message -----
From: "Shannen Durphey" <shannen@grolen.com>
To: <gmecm@diy-efi.org>
Sent: Tuesday, June 27, 2000 9:07 PM
Subject: Re: BPW and Cylinder Vol.?


> You're talking about the values in the tables that begin at 0xC42D?
> Shannen
>
> Romans, Mark wrote:
> >
> > That's what I did on my 165 to "Adjust" the maf sensor values.
> > Mark
> > ----- Original Message -----
> > From: "Shannen Durphey" <shannen@grolen.com>
> > To: <gmecm@diy-efi.org>
> > Sent: Tuesday, June 27, 2000 8:24 PM
> > Subject: Re: BPW and Cylinder Vol.?
> >
> > > Funny what you can find by reading through old mail...
> > > So you're disabling CL and watching the O2 values to determine
> > > rich/lean?
> > > How about Roger Heflin's suggestion to set 14.7 AFR and leave CL
> > > enabled, using BL and INT as guidelines?
> > > Shannen
> > >
> > > rrauscher@nni.com wrote:
> > > >
> > > > To force open loop, set the enable temp to the max value. For
> > > > tuning the VE tables, also set the open loop afr ratio to 14.7.
> > > >
> > > > On the '747 there are two tables to change, one for the afr
> > > > vs. temp., and the other is afr vs. map. In this manner, you
> > > > can then 'discover' what the ve is at each point in the table.
> > > >
> > > > This is really tuning in reverse, but hey, it works <g>.
> > > >
> > > > BobR.
> >
> --------------------------------------------------------------------------
> > --
> > > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> > > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> > >
> > >
> >
>
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org