RE: single vs double batch fire

[Mike Rolica <mrolica@meridian-mag.com>]

The bin I'm currently using uses single fire for low bpw..... when bpw gets
so low it switches to single fire..
Gonna play with it when I throw the 30lb injectors.
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	romans@starstream.net [SMTP:romans@starstream.net]
	Sent:	Thursday, August 10, 2000 12:57 PM
	To:	gmecm@diy-efi.org
	Subject:	Re: single vs double batch fire

	Looking some bins and the air fuel mode words, working on a
different
	problem i have found  that (89 Code) only the 305 5 speed bin uses
the
	single fire mode.  All other F&Y body bins that I have looked at use
double
	fire mode.
	Mark
	----- Original Message -----
	From: "NickG" <nikog@mediaone.net>
	To: <gmecm@diy-efi.org>
	Sent: Thursday, August 10, 2000 9:03 AM
	Subject: single vs double batch fire


	> ECM in question: '165 with type 32 Prom
	>
	> What is the difference between single fire and double fire on the
	injectors?
	> I've noticed that the eprom has an injector size value for each of
these
	> instances. Should these values always be the same? At what point
does the
	> ECM switch from one mode to the other?
	>
	> If it works like I imagine, I would like to set the low-speed
injector
	> sizing to open the injectors for a smaller amount of time, and the
	> high-speed sizing to something that will open the injectors
longer. Will
	> this work?
	>
	> Thanks,
	> Nick
	>
	>
	>
--------------------------------------------------------------------------
	--
	> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	> in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
	>
	>

	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org