Re: Pin functions determined by PROM?

["D. Barry Stubbs" <z24man@earthlink.net>]

Brent Obermiller wrote:
> 
> Also, I believe that the 3.1 has a Linear EGR (stepper
> motor) and the 2.8 a vacuum controlled one.
> -Brent

I'm not sure about the stepper motor EGR, but you're correct about the
vacuum controlled version on the 2.8s.  The ECM does have control over
the vacuum vent solenoid.  But, I never got a chance to look at the EGR
functions since the VSS never made it above zero.

========================================================================
D. Barry Stubbs                                    http://surf.to/z24man
(912) 745-9429                                     AOL IM: thez24man
z24man@earthlink.net          BNet Member #828     ICQ #5409648
#101DSP MidGa Region SoloII   94 Q4 5spd Aqua Z26  88 2.8 5Spd White Z24
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org