Re: 16183247

["Programmer" <nwester@eidnet.org>]

Hmmm...have to check that out. Cool.

Lyndon.
-----Original Message-----
From: David Cooley <n5xmt@triad.rr.com>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: August 22, 2000 8:19 AM
Subject: Re: 16183247


>At 02:33 AM 8/22/2000, you wrote:
>>Had the car here this morning...interesting memcal. It's about half
>>the length of a regular memcal with the ESC board over top. You've
>>gotta snip the legs off the ESC to erase the chip. I'll send ya the binary
>>tomorrow a.m.
>
>I built a little board that moved the ESC off to the side and had the EPROM
>in a socket.  Fit under the cover in the PCM nicely!
>It's on the DIY-EFI incoming directory and it's called memcal.jpg.
>I used a wire wrap socket for the Chip, and the pins went thru the board
>into the memcal base.  I ran the 6 wires to the ESC seperately so it was
>off to the side... Worked like a champ!
>
>===========================================================
>David Cooley N5XMT Internet: N5XMT@triad.rr.com
>Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
>I am Pentium of Borg... Division is Futile!
>===========================================================
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org