Re: Simple fuel cut question.

[Len Sabatine <sabatine@epix.net>]

At 12:27 AM 8/26/00 +1000, you wrote:
> Hi All,
>
> This may sound like a silly question, but I just want clarification on this.
> When changing RPM Based Fuel Cut-off Values is this correct -
>
> HI RPM FUEL CUTOFF - LOW LIMIT, is the value to re-enable the fuel once
> cut-off is active.
>  <<<      Fuel = Resume
> HI RPM FUEL CUTOFF - HIGH LIMIT, is actual value to enable cut-off.
> <<<       Fuel CutOff= Max Rpm.
> FUEL CUTOFF TIME THRESHOLD, is the time fuel is cut-off in an attempt to
> reach the FUEL CUTOFF LOW LIMIT RPM again.
> << Hysteresis Val = # between On / Off switches = Prevent Hunting.
   Len


> Thanks,
> Ross Myers
> Melbourne, Australia
> E-mail : ponty@axis.jeack.com.au
> Stuff : http://www.jeack.com.au/~ponty
> <><><><><><><><><><><><><><><>
>
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org