Re: 5.7L Y body 6 spd binary?

["TK" <terryk@foothill.net>]

Thanks Ludis, That's an easy solution.

Terry

> B21.
> 
> Your harness plugs might not have provisions for a pin at that position.
>  In that case, you can solder a jumper internal to the ECM between B21
> and C2, and then use C2 as the input.
> 
> -- 
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org