quick EFI harness question

[Vinnie Moscaritolo <vinnie@vmeng.com>]

HI;

In my custom installation I have opted to  build my own wiring 
harness to go from a 730 ECM  to the various sensors and motors.  My 
question is does anyone think there would be a problem with inserting 
a connector (round Mil-spec AMP with gold/tin pins) in between the 
ECM and the sensors..

I didn't think there would be a resistance problem, but wanted to ask opinion.

thanks
Vinnie Moscaritolo KF6WPJ ITCB-IMSH
http://www.vmeng.com/vinnie/
PGP: 3F903472C3AF622D5D918D9BD8B100090B3EF042
-------------------------------------------------------

"There are more things on this planet with fangs,
claws, poisons and scales than there are things
that are warm fuzzy and full of love.
- It's a simple fact"
                             -  James A Keating
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org