Re: Promedit help

[WEG1192@aol.com]

In a message dated 09/07/2000 10:27:40 PM Eastern Daylight Time, 
shannen@grolen.com writes:

<< What are you trying to change?  The definition of a table, or a value
 in the prom that's displayed in the table?
 
 A lst file is not a .bin file.
 
 Which version of Promedit are you using?  I spent a little time with
 this editor before I switched to another, but I seem to remember it
 wasn't hopeless. : ) >>

I'm trying to change a value in the main spark table using Promedit version 4 
with the   730_727 .ecu file. Everytime I type in a numver it says Command 
not recognized or something to that effect.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org