Re: knock sensor installation

["s. douglas taylor" <x5gb7uk9@wna-linknet.com>]

-----Original Message-----
From: Shannen Durphey <shannen@grolen.com>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: Friday, September 15, 2000 12:14 AM
Subject: Re: knock sensor installation


>Many knock sensors are installed in the coolant drain hole in front of
>the starter.  I think it's 1/4 NPT.  This is especially true of sbc
>applications.
>Shannen  


On smallblocks, the knock sensor is screwed into a hole just above the
oil pan on the side of the block.  There's a hole on either side,
usually with a square headed plug in it.

--steve

Should be a 1/4" pipe threaded hole (SBC)  slightly above and in front of
the starter, that's the oem spot.  (goes into water jacket)
Bruce


Bruce, Steve, Shannen,

thanx, i can do that. 
now my next question is...

ciao...douglas  

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org