Re: Traction Control

[Len Sabatine <sabatine@epix.net>]

   Is your Z28 Equipped with the OPTION Hardware and on the Parts List 
Label in glove box ?
   If your rear axles BOTH have a reluctor / transducer on them , you have 
Traction Control. If not , It's a
   non issue , far as what I've seen. Non TC have 1 x 'ducer above ring 
gear , on top of axle housing.

   Len

> Tunercat has a selection and table for traction control for my 94 Z28 
> which is enabled,  but traction control isn't engaged.  Does anyone know 
> if there is an electrical switch to enable traction control?  If so on 
> which pin does the signal enter the PCM?  I
> don't see anything labeled 'Traction control' on the PCM pinout document.
>
> Bill
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org