Re: Reading hex

["Programmer" <nwester@eidnet.org>]

Kevin,
the top row of columns should go 0123456789ABCDEF (16 wide)
and down rows should go 00,10, 20, 30 ... A0, B0, ...100, 110, and
further down to 1A0, 1B0---that's the row you want. Go over 4 places to 1B3.
1B0, 1B1, 1B2, "1B3", 1B4, etc...
That's the spot you're looking for.
Hope this helps...

Lyndon.
-----Original Message-----
From: Kevin R <KEReyn@gte.net>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: September 25, 2000 12:01 AM
Subject: Re: Reading hex


>I'm using the edit capabilities of the software that came with the used
>Xeltec burner I have.
>It looks like a table with X and Y addresses or am I reading it wrong.
>0 1 2 3 4
>A
>B
>C
>Also, all the entry points seem to be a 2 number entry.
>I guess what's giving me the problems is I don't know how to the 1B3=435
>part.
>
>Kevin R
>
>
>
>> Ok, I'll try to answer this.  I had trouble with locations, too.  But
>> not in the same way.  0x1B3 is a location.  Some editors will show it
>> as 1B3, some as 01B3, and there's other variations.  If I've
>> understood it right, it's a relative location, one which is 1B3 (or
>> 435) bytes from the beginning of the data.
>>
>> What hex editor are you using?
>>
>> If you're adjusting the egr enable temp, lowering the value in the
>> prom will raise the temp where the egr is allowed to turn on.
>> Shannen
>>
>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org