Re: '747 + 6 Cyl + Turbo?

[ECMnut@aol.com]

If you ever get to the point where you can fab a port injection
setup, it sounds like you'll be a good match for the Syclone Typhoon 
4.3 ECM & cal.  They had a 4400rpm rev limiter from the factory,
and made 285hp, 350lb/ft stock.  The 1991 4.3 that they used was
an "all bottom end torque" engine, much like your 3.9.  Turning
the boost up a little can put an otherwise stock 3800lb Syclone in the
mid-high 12 sec range in the 1/4 mile.
The Syclone code has been totally disected.  The ECMs are a little
hard to come by, but they also came in '88 quad-4's and 87-90 turbo
sunbirds.
HTH's
Mike V
 
>    1969 FJ40 Toyota Land Cruiser
>        Vehicle Weight: about 3800 lbw
>        Gearing: 4.11:1 diffs, 4 speed manual trans, 35" tires
>        Motor: F engine: straight 6 metric clone of stovebolt six of Chevy 
> fame, .030                     overbore, .030 shaved block/head
>                    around 3900 cc displacement, doesn't rev over 4000 RPM
>                    cast aluminum intake for 2bbl carb, steel tri-y header
>    My current short-term goal is to simply install a throttle body/'747 
> system from a 4.3l GM truck or van. In the beginning I just want it to work 
> well enough to drive around daily. Question: Do you suppose re-programming 
of 
> the ecm will be neccesary?
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org