Re: 730 ECM Swap

[WEG1192@aol.com]

In a message dated 11/06/2000 11:48:14 AM Eastern Standard Time, 
nacelp@bright.net writes:

<< Clever splicing does >>

Yes, I only meant that the sensor leads could be spliced (actually tapped 
into) at the sensor ends to allow the same wires to share two sensors, like 
MAF and MAP. That way, you could run both setups just by exchanging ECMs 
under the dash and swapping over the sensor connectors under the hood. This 
is why I asked if there were any other sensor swaps I might be missing. I 
have studied the MAF harness diagrams on DIY but I have never actually wired 
one up.   JW
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org