Re: Just got my TPI running...questions...

[Tedscj@aol.com]

In a message dated 11/12/00 9:02:58 PM Eastern Standard Time, 
shannen@grolen.com writes:

> Before diagnosing this code, make sure that it's current.  Clear all
>  trouble codes, start the car, see if it returns.
>

I did this a few times and it returned almost immediately.  It did not set 
with just the ignition on, but set almost as soon as the engine was started.

 
>  Running the wiring harness too close to the plug wires has been known
>  to cause intermittent code 42/43.

THIS I will have to check out.  They are indeed fairly close.  I don't know 
how far I will really be able to separate them because the engine bay is so 
tight, but perhaps I can do better.
Thanks for the advice,
Ted

>  Shannen
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org