Re: 730 ECM Swap

[Shannen Durphey <shannen@grolen.com>]

War stories?

Once upon a time, I bought a 350 for $50.  First engine with a 4bbl,
and man was I excited!  The seller even offered to lift the engine for
free with his log skidder if I pulled all the bolts.  Silly me, I
forgot one bolt at the trans.  But that didn't stop the skidder.  75
Camaro goes up, down about 5 times until the trans finally breaks, and
15 minutes later I get to drive away with my bargain priced engine and
an extra 1/4 of a THM 350 as a parting gift.

Redneck scrap yards are the best!

Shannen

ECMnut@aol.com wrote:
> 
> In a message dated 11/13/00 3:31:34 AM Eastern Standard Time,
> ludis@cruzers.com writes:
> >  Heh!  I've seen how they pull radiators out of cars:  They stab them
> >  with a fork lift fork.  Then they lift the car by the radiator until the
> >  radiator pulls out.  I've also seen them use a car as a broom (or
> >  bulldozer blade.)
> 
> That paints an interesting picture.  When in high school, back in the
> stone age, I drove a boom-truck, yanking engines all summer.
>  I "almost" had a 74 nova lifted off the ground with a chain aroung
> the Rochester 2-jet carb..   <boredom is dangerous>
> Then the damn body ripped from the cast iron baseplate.
> Mike V
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org