[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: my 355/ 730ecm truck

To: <gmecm@diy-efi.org>
Subject: Re: my 355/ 730ecm truck
From: romans@starstream.net (Romans, Mark)
Date: Mon, 13 Nov 2000 21:00:58 -0800
Organization: Romans Motorsports
References: <000c01c04c61$48c23640$c20eea18@lvcablemodem.com> <005301c04d08$1964d6d0$c20eea18@truspeed> <001401c04d14$415ef240$ced5cd3f@computer> <000001c04db9$f9f119f0$0200a8c0@mikesbasement>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Couldn't be worn out from HP!

Ha!

----- Original Message -----

From: Mike Rolica

To: gmecm@diy-efi.org

Sent: Monday, November 13, 2000 12:30 PM

Subject: my 355/ 730ecm truck

Well truck is dead at 350 000km.. wheel bearings, rotors balljoints...rear end,, u joints..

soo the motor is being transplanted into a 87 rx7 gxl..

being close to 1200 lbs lighter i wonder what it will do in the 1/4 :o)

mike

References:
- Question about WOT table in $8D bin
  - From: "NRG" <euro@lvcm.com>
- Re: Question about WOT table in $8D bin
  - From: "Edmond" <euro@lvcm.com>
- Re: Question about WOT table in $8D bin
  - From: romans@starstream.net (Romans, Mark)
- my 355/ 730ecm truck
  - From: "Mike Rolica" <97005620@lambton.on.ca>

Prev by Date: Re: 10 LED O2 monitor
Next by Date: Re: head gaskets
Previous by thread: my 355/ 730ecm truck
Next by thread: Re: Question about WOT table in $8D bin
Index(es):
- Date
- Thread