Re: Question about...

[timsiford@hushmail.com]

Bob,

I thought you said that you were running an Isky cam?

What intake system are you running?

tim

At Thu, 16 Nov 2000 11:30:49 -0800, "NRGZ28" <euro@lvcm.com> wrote:

>
>The same exact cam I'm running !! lol
>
>
>----- Original Message -----
>From: <timsiford@hushmail.com>
>To: <gmecm@diy-efi.org>
>Sent: Thursday, November 16, 2000 9:45 AM
>Subject: Re: Question about...
>
>
>> Bob,
>>
>> I am running a CompCams Xtreme hydraulic roller.  I pulled the following
>> specs off of Comps Site.  HOWEVER, I had this cam custom ground on 
>a
>112LSA
>> (before comp offered that as a standard grind) and I am running the 
>cam
>> with 1.6 rollers as compared to the 1.5 ratings.  The specs below 
>are for
>> the 110 LSA version.  They didn't have the specs on the 112 version 
>up yet
>> ...
>>
>> PART # 08-422-8
>> GRIND NUMBER: CS XR270HR-10
>> ENGINE: CHEVY SM BLK 305-350
>>                  INTAKE   EXHAUST
>> VALVE ADJUSTMENT  HYD      HYD
>> GROSS VALVE LIFT   .495     .502
>> .006  TAPPET LIFT  270      276
>> VALVE TIMING     OPEN     CLOSE
>> AT  .006 INT     29 BTDC  61 ABDC
>>          EXH     72 BBDC  24 ATDC
>>
>> THESE SPECS ARE FOR CAM INSTALLED
>> AT  106  INTAKE CENTER LINE
>>                   INTAKE  EXHAUST
>> DURATION AT .050    218      224
>> LOBE LIFT         .3300    .3350
>> LOBE SEPARATION     110
>>
>> Tim