[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Question about...
Ok, maybe you can help with this mystery. What does your engine like
for total wot timing? And the basic engine parts?
Thanks,
BobR.
NRGZ28 wrote:
> The same exact cam I'm running !! lol
>
> ----- Original Message -----
> From: <timsiford@hushmail.com>
> To: <gmecm@diy-efi.org>
> Sent: Thursday, November 16, 2000 9:45 AM
> Subject: Re: Question about...
>
> > Bob,
> >
> > I am running a CompCams Xtreme hydraulic roller. I pulled the following
> > specs off of Comps Site. HOWEVER, I had this cam custom ground on a
> 112LSA
> > (before comp offered that as a standard grind) and I am running the cam
> > with 1.6 rollers as compared to the 1.5 ratings. The specs below are for
> > the 110 LSA version. They didn't have the specs on the 112 version up yet
> > ...
> >
> > PART # 08-422-8
> > GRIND NUMBER: CS XR270HR-10
> > ENGINE: CHEVY SM BLK 305-350
> > INTAKE EXHAUST
> > VALVE ADJUSTMENT HYD HYD
> > GROSS VALVE LIFT .495 .502
> > .006 TAPPET LIFT 270 276
> > VALVE TIMING OPEN CLOSE
> > AT .006 INT 29 BTDC 61 ABDC
> > EXH 72 BBDC 24 ATDC
> >
> > THESE SPECS ARE FOR CAM INSTALLED
> > AT 106 INTAKE CENTER LINE
> > INTAKE EXHAUST
> > DURATION AT .050 218 224
> > LOBE LIFT .3300 .3350
> > LOBE SEPARATION 110
> >
> > Tim
> >
> >
> >
> > At Thu, 16 Nov 2000 11:07:02 -500, rrauscher@nni.com wrote:
> >
> > >
> > >
> > >Tim,
> > >
> > >I was wondering what cam you are running in the 350. (I think
> > >you once posted a CompCams). Believe it or not, with the Isky
> > >cam that I'm running in a 327, I am also running 42deg of
> > >timing at WOT (~12.6afr). Aluminum L98 heads. The difference
> > >in how well the engine runs going from 36/38deg to 42deg is
> > >substantial.
> > >
> > >I approached this value slowly and with caution. Apparently,
> > >with this cam and the valve timing, it likes a lot of ignition
> > >advance. I was surprised at my results. This is supposed to be
> > >due to an early intake closing.
> > >
> > >It will be interesting to get some true wot afr readings. . .
> > >
> > >BobR.
> > >
<snip>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org