Re: Winbin problems

[Len Sabatine <sabatine@epix.net>]

At 10:25 PM 11/28/2000 -0500, you wrote:
> ok, I seem to have a lot of problems trying to load any of the 747 bins with
> different ecus files I was able to find on around.  The most important bin I
> need to get to work on would be the arpc7509, which I only know that it for
> a 5.0L manual.  If anyone would have a bin for a 747 around 89 5.0L manual,
> 4x4 and with TBI.  Well any manual 5.0L bin would be really appreciated.
> And then a nice and working ecu would also be really appreciated, and is
> even more important than a bin at this point.  I really don't know why it
> give me errors when the ecu and bin is entered, because they should match?
> By the way, you can send me the files attached to a message directly to my
> email.
>
> maybe one other question, if I got a 747 from a 4.3L that I would like to
> use on a 5.0L, could I just burn a eprom that would be for a 5.0L, would
> that solve the problem or will the there be a problem anyway? Since it's a
> TBI, if I just put some extra fuel and maybe adjust the timming curve a bit,
> maybe it would be correct?

   In addition , use calpack [netres] for a 305. :)


>     Math B
>     fireb76@videotron.ca
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org