Re: Jargon, Terminology, Terms ....

["Bruce Plecan" <nacelp@bright.net>]

In reply to what I thought I had deleted. ??

Mask ID locations can vary,  on the 16Kb and 32 Kb bins they are usually at
0008.
On the 64Kb bins so far all I've seen had them at 4008
Bruce

----- Original Message -----
From: "Bruce Plecan" <nacelp@bright.net>
To: <gmecm@diy-efi.org>
Sent: Tuesday, December 05, 2000 4:12 PM
Subject: Re: Jargon, Terminology, Terms ....


> Mask ID locations can vary,
> for the 128 and 256
>
>
> > For further clarification, the mask ID is at location $8008 as seen by
the
> > microcontroller( through its memory map, correct?  In other words, it is
> at
> > $0008 if one were to just straight read the EPROM?  The reason I ask is
I
> > know in a $6E prom it is at $0008 when viewing with a hex editor.  I
> haven't
> > seen an $8D chip yet. :-(
> >
> > Steve
> >
> > -----Original Message-----
> > From: timsiford@hushmail.com [mailto:timsiford@hushmail.com]
> > Sent: Tuesday, December 05, 2000 1:17 PM
> > To: gmecm@diy-efi.org
> > Subject: Re: Jargon, Terminology, Terms ....
> >
> >
> > Shannen, Bruce ...
> >
> > Thanks.
> >
> > As a specific quick example ...
> > Scan ID = Prom ID = Positions $8000-$8001for '86-'92 TPI F Bodies
> > BCC = AUJP, ANJF, etc = 4 letter designation on Silver GM sticker
> > Mask = 8D, 6E, 32, etc = Position $8008 for '86-'92 TPI F bodies.
> >
> > Thanks again ... truly appreciate it.
> >
> > Tim
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org