Re: DIS for GMECM

[Shannen Durphey <shannen@grolen.com>]

Are you saying there are only 3 values to change in order to convert
an engine from
dizzy to DIS?  Or that there are only 3 values to change in order to
use the 3.1 cal. with an 8 cyl?  Or something else...? 

Shannen

Jeremy Gonyou wrote:
> 
> AFAIK, there are only three values you need to change:  Initial advance, max
> advance, and max retard.  All of these locations are known for the 3.1
> masks.
> 
> Jeremy
> 
> >There are "timing values" between the chips which are not easily
> >swapped.
> >But for someone using a 165 or 730, it may be possible to use a
> >2.8/3.1 calibration as a base point.  The trick there would be
> >identifying the table locations.  Is tunercat offering anything for
> >the 30 degree v-6's yet?
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org