Re: Olds 350 donor

[Bob Valentine <bob@tecmark.com>]

That's how it's done on a van.   Harness comes down behind dist, snakes
over to under the driver's seat.   Has a nice pass-thru grommet where it
goes thru the floor, and a metal shield to guard the harness where it goes
under the frame rail. 

On 2nd thought using a '727 wasn't such a good idea.  I've burned 80 chips
or so, and a few of those were only in the car for less than a couple of
miles... 

-> Bob Valentine
-> bob@tecmark.com

At 03:17 PM 12/17/2000 -0500, you wrote:
>What under the passenger seat?.
>How about along frame rail, and then thru floor pan near seat.  Means long
>runs but, is an answer
>Or gather wiring by dissy, then down tranny tunnel and enter by passenger
>seat tracks (again floor pan area).
>Bruce
>
>
>
>
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org