Greetings from a "new" member

[Dig <turbodig@usa.net>]

This is my first post to this list, so I wanted to
take a little time to do an intro. 

I recognized a lot of names while rooting through the
archives... some folks that I hadn't seen/heard from 
since the days of the HotRod list 8-9 years ago. It's 
good to see the same old voices (does that make sense?)
are still out there plugging away. 

Anyway, enough  of old-home-week. I've been working on 
GM ECMs (specifically the '749/$58 code) for about 6 
years now. My current project, (along with continual 
tweaking of the $58 code to make the boost control work
decently) is a scan-tool product for the Syty/TGP/Sunbird
that I call the F.I.S.T (Forced Induction Scan Tool). 
It's a VB app using only the common MS controls, and it 
currently communicates quite well. 

When I'm not doing that (and the weather permits), I'm 
trying to coax my '91 Syclone: 

http://www.syty.org/member_mods.html#letter_b

...ever closer to the 11's. It's run a traction-limited 
12.53@105, with much work yet to do on the new boost routine
and getting the TCC to lock where I want it too. 

I'll spare all the dumb questions until I've had a chance
to read through the archives and catch up. Which looks like
it'll take a while...

Later,
Dig
turbodig@usa.net
(formerly sbarthol@cca.rockwell.com, among others)
'91 Sy - 12.53 @105/7.98 @88 

____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org